A: Depending on the pool's normal evaporation, the level decreases approximately 1" to 2-1/2" per week. When the days are warm and the nights cool, evaporation is at it's highest. Using the ordinary plastic bucket you can perform this simpletest to determine if your pool is leaking.
Bring pool water to normal level (middle of the skimmer). Place a bucket on the first or second step of the pool. Fill the bucket with pool water to same level as the pool. Mark the water level on the inside of the bucket. Shut off the pump and mark the pool water level on the outside of the bucket. Resume normal pump operation. After 24 to 48 hours, compare the two water levels.
If the pool water goes down more than the water inside the bucket, there is probably a leak. Repeating the test is recommended if any precipitation occured during this procedure. If your pool is equipped with an auto fill, be sure to shut off the water supply. The test is invalid after 48 hours.
A: First, determine the average depth of your pool by taking the depth ofthe deepest end of your pool and adding the depth of the shallowest end (in feet). Divide this number by 2. This number is the average depth. Continue with the directions below based on the shape of your pool.
*Square or Rectangular* Total Gallons = length x width x average depth x 7.5 (in feet)
*Circular* Total Gallons = diameter x diameter x average depth x 5.9 (in feet)
*Oval* Total Gallons = long diameter (in feet) x short diameter (in feet) x average depth x 5.9
Q: How long should my filter run each day? A: Your pool filter is the most important component in keeping yourswimming pool clean. Ideally, a filter should run all the time formaximum circulation and debris removal. A minimum of 8 hours a day insummer and 4 to 6 hours per day in the winter is highly recommended.
A: This is dependent upon several factors: the size of your pool, the size of your pool filter, the type of pool filter you have, and the bather and contaminant loads. Most manufactures recommend a complete filter tear down and cleaning at least twice a year
A: Pools should be disinfected continuously by a chemical which imparts aresidual effect. Chlorine is a type of "disinfectant", also called a "sanitizer". Disinfects or sanitizers destroy living microorganismsand bacteria, preventing the transmission of disease. There areseveral types of disinfectants, such as chlorine, bromine, saltchlorination, ozone, and UV light. Pools need a disinfectant with ameasurable residual.
A: Salt chlorinators do have many advantages over the traditional hand chlorinated system.
Thesalt chlorinator sanitizes pool water by converting the salt in thewater to a chlorine gas, sanitizing your water and then changing back to salt. Adding fresh water to the pool does cause the salt levels to drop therefore salt pools do require salt to be added, usually two to three times per year.
Also, the salt in the water works as a natural water softener, creating a much more comfortable environment for swimming in comparison to the harshness of a hand-chlorinated pool.
Safety, as always, is the greatest matter. When it comes topools, the most important thing is that your family is kept safe from bacteria and algae. Chlorine does not have a long life, and therefore even if you test the water for chlorine prior to swimming and find the level is correct, after an hour or so that chlorine could have completely dissipated, leaving the water open for dangerous bacteria. Because a salt chlorinator will continue to sanitize your pool whilethe pool is in use, the chlorine in the water is constantly beingreplaced with "new chlorine", keeping the water sanitized at all timesand keeping your family safe.
Salt cells do require manual periodiccleaning and maintenance. Also your swimming pool's pH will tent torun very high and require large doses of muriatic acid.
A: The sum total of all the dissolved material in the water is called "total dissolved solids" or TDS. Sources of TDS in the water include disinfectants, balance chemicals, calcium hardness, source water, bather waste, algaecides, total alkalinity, wind blown dust and dirt, phosphates, nitrates, and sulfates.
TDS buildup is inevitable. Every time you add chemicals to the water, the TDS increases. Even adding makeup water to the pool increases TDS. When water evaporates, only the pure water leaves the pool and all material that was dissolved in the water remains behind. This builds up overtime, increasing the level of TDS.
The ideal range of TDS is from 1000 to 2000 PPM, and the maximum level is 2500 PPM to 3000 PPM. There is no way to reduce TDS chemically. You must drain or partially drain the pool and replace with fresh water.
A: Only if you have a submersible pump and are familiar with adding start up chemicals (Cyanuric Acid, Stain Out, Chlorine, Acid). Draining a pool using the pool filtering pump usually will not work once the water level drops below the skimmer, and it causes a lot of strain on your filter grids. We do offer a draining service with balancing of chemicals once refilled.
A: Typically every 5 to 7 years a pool should be drained and acid washed to remove discoloring caused by chemicals. An acid wash is, put simply, purposeful stripping of a tiny layer of plaster, exposing fresh plaster beneath.
An acid wash will generally removesuperficial stains, fine scale deposits, and various colored depositsfrom the plaster. The process strips off (dissolves) a very thin layerof plaster, and will therefore generally restore 75 to 85% of theplaster's brightness. An acid wash will not remove heavy deposits orstains that have penetrated through many layers of plaster.
As a rule, acid washing a pool should be done only by a licensed professional.
A: No. Exposure to metals dissolved in the water, particularly copper, iron,and manganese causes your hair to turn green. When metals attach to the hair shaft and are oxidized by the chlorine, they can leave behind a green residue. To remove the metals from your hair use a swimmer's shampoo which contains the chelating chemical ethylenediaminetetra-acetic acid (EDTA).
A: CONVENIENCE: Many pool owners simply cannot afford the time it takes to maintain a pool on a regular schedule. Beachside does the work and takes the time to inspect the pool and the equipment for proper operation. If small parts are needed, they are obtained and installed on the next service date, saving you an inconvenient trip to the pool store. There's no need to lug home gallons of acid and chlorine and find a place to store them safely when not in use.
COMPETENCE: We are experts because we maintain pools for a living. Knowing what it takes to obtain the proper water chemistry is what we do daily. We know what to do if we spot an algae bloom. As with most things, consistency is critically important, and that is why we come every week. We notice changes in the water balance and adjust accordingly.
COST EFFECTIVE: It will cost you a little more for us to maintain your pool, but probably not that much. You will probably spend an average of $30.00 to $40.00 per month for the necessary chemicals, including chlorine tablets, muriatic acid, shock treatments and chemical test kits. For only a few dollars a week more, we will come to your house and do it all for you. In addition, maintenance and proper chemistry in the water can save you thousands in unnecessary equipment repairs.
WHAT IS YOUR TIME WORTH?: Lets do the math. If you spend an estimated 1 hour per week x 4 weeks per month cleaning your own pool, and let's say you earn $20 per hour at your job $20 x4= $80, plus you are spending $30 to $40 per month on chemicals (and time to pick up chemicals). It's costing you $120 per month at best to clean your own pool.
A: Yes! We highly recommend assisting us in emptying your skimmer and pump baskets especially during the fall/ windy season. If your baskets are overflowing the leaves will impair the water circulation and your pump will run dry.
A: No more than if you have only grass or cement in your back yard. Most backyards are equipped with a drainage system so there is nothing to worry about. Once the pool water level crests it is the same as having a cement yard. If you are still concerned, you can backwash your filter for a few minutes to get the desired water level. Be sure to add fresh D.E. as soon as you are done or the filter will need to be cleaned again.
A: Anaverage sized spa 580 gallons with a gas pool heater should take approximately 45 minutes to get from 55* to 104*. If it is taking substantially longer, your heater may be too small or it needs service.
A: If you have an electric heater then you have a portable spa/ hot tub, and it must be covered when heating it. If you do not have a cover, get one right away. Portable spas are made to be heated and stay heated. Electric heat elements heat water very slowly at approximately 4 to 5 degrees per hour. It takes approximately 6 to 8 hours typically to get to 104*, which is why it must stay covered to retain the heat.
A: We offer weekly pool cleaning maintenance service in the following cities only:
Aliso Viejo, Anaheim Hills, Brea, Costa Mesa, Coto De Caza, Dove Canyon, El Toro, Foothill Ranch, Fountain Valley, Huntington Beach, Irvine, Ladera Ranch, Lake Forest, Laguna Beach, Mission Viejo, Newport Beach, Newport Coast, Orange, Orange Park Acres, Portola Hills, Rancho Santa Margarita, San Clemente, Santa Ana, Trabuco Canyon, Tustin, Villa Park.